|
|
|
Result of careful development and specific research on materials and components, the hydraulic chain saw machine TCI260VH is the new frontier in chain cutting. Thanking to some ultimate solutions this machine can guarantee maximum efficiency and performance, assuring reliability and safety in any working conditions. A special feature of the TCI260VH is the main pump of the chain: it is a variable delivery type, that allows an accurate and precise regulation of the cutting speed, in order to optimize the performance according to the different hardness of materials.
The TCI260VH can make vertical and horizontal cuts form 1,00 up to 2,00 mt long
It is possible to work on marble and soft stones, using tungsten bits, both with water and dry; in case of hard stones the machine can be supplied with a special chain with polycrystalline diamond bits; also in this case the TCI260VH can operate both with water and dry.
The hydraulic system installed on the machine is specifically studied and properly designed, made using the best components available on the market, so that to guarantee utmost reliability and safety.
A single motor controls two pumps on line. The former pump, variable delivery type, controls the chain movement; the latter is a piston pump, compensated type. This device is a special one, able to raise to the working pressure only the exact amount of oil necessary to the work, not the entire amount of the tank, so that to avoid loss and waist of unused oil during the cutting phase. This system allows maximum energy saving and environmental respect.
Thanking to an air/oil heat exchanger, the machine can work also in some geographical areas, where the particular environment conditions - desert or lack of water on the quarry site - oblige to work dry.
In order to make the transport easy, the TCI 260 VH is supplied with four independent hydraulic pistons, that allow to perfectly align the machine with the cut. Thanking to the particular leveling system, the operation is extremely easy and allows the correct moving of the rails for best positioning. |
|
